Karaoke Function; Technical Specifications; Troubleshooting - Regent D-1000 Bedienungsanleitung

5. Karaoke function

1. Connect a supported microphone to the
MIC 1 or MIC 2 port on the front panel as
shown in the adjacent illustration.
2. Adjust the microphone volume and echo
effects in karaoke stops.
3. Turn on background music (USB or Disc)
4. Adjust the sound level with the DVD remo-
te control.
NOTE: Note that some mi-
crophones have a switch. Put
it in the correct position.
The karaoke function works with any backgro-
und sound (USB, DVD, CD).
You can change the karaoke effects settings in
Sound settings > Karaoke settings.

6. Technical Specifications

System
Reception frequency
Signal to noise ratio
Sound distortion and noise
Audio output
Video output
Power Supply
Supported drives
20
PAL/AUTO/NTSC
20HZ-20KHZ (at 1KHz 0dB)
≥90dB (at 1KHz 0dB)
≥-60dB (at 1KHz0dB)
2.0+0-1.0 Vrms
Composite: 1.0±0.2Vp-p
Load impedance: 75Ω
110-240V~50/60Hz
DVD/VCD/CD/MP3/Photo CD/
SVCD/JPEG/MPEG-4

7. Troubleshooting

Before Requesting Service check the following guide for possible cause of a problem before
contacting service.
Symptom Solution
No power • Correctly connect the power cord to a wall outlet.
• Select the correct picture input on the TV.
No picture • Connect the picture connector to the TV correctly.
• Turn on the TV.
• Check the audio connections.
No sound
• If you are using an AV receiver check a
different connector or input settings.
The playback picture
• Clean up the disk.
is of poor quality
• Insert a disc if there is no disc in the drive.
• Insert a suitable disc in a supported format.
DVD player does not
• Clean the disc.
start playback
• Insert the disc in the correct direction.
• Disable the age lock or change its level.
• Clean the device with a cloth
moistened with alcohol.
• Clean the disc.
There is a humming or noise
• Correctly connect the speakers
and their components.
• Move the TV away from the audio equipment.
• Point the remote control at the
infrared sensor of the DVD.
• Use the remote control within 5m.
The remote control is
not working properly
• Remove the obstacles.
• Replace the batteries in the
remote with working ones.
Color is distorted or • If the picture is distorted or smudged, check that
not displayed the color system is set to match that of the TV set.
• The DVD software is blocking the
function at the moment.
The ø symbol appears
in the display • The software does not support this function.
• The function is not available at the moment.
EN
21