Noveen MLB910 Xline Betriebsanleitung Seite 13

If Menu buttom is pressed in the standby mode or after schedule setting, the product will enter the
function selection mode. Each time this button is pressed, the product will switch to the corresponding
function and indicator will flicker. The operating time can be adjusted through the +/- buttons. The
product will begin to work 10s later. If Menu buttom is pressed during work, the unit will stop preset or
working and become standby.
Tips:
1. Function switching follows the sequence below: standby, cook, heat and standby.
2. The preset function cannot work during function selection. If want to use preset function, press
Menu to make "OF" (standby mode) display on the operation panel.
5. Keep warrm function
Display on operation panel during keep warm See picture 8
Upon end of the set operating time, the item will enter the keep warm mode automatically and last for
2h by default. User can wait till the item enters standby after the default keep warm time is completed,
or press Menu to stop work, then power it OF (the indicators will go out) and unplug the power cable.
Note: If want to open the top cover during cooking/heating, pay attention to the steam and the boiling
water from the lunch box.
Cleaning and maintenance

After use, unplug the power cable.

Do not use hard steel wire but dishwashing liquid and sponge to wash the bowl and the top
cover to avoid damage to their surfaces.

When the item is dirty, do not wash it in water but wipe with with a wet towel to prevent
electric leakage and accidents.

If the item is not to be used for a long time, clean it, put it into its package and place it in a
dry and well-ventilated place.
Troubleshooting
Problem
The power indicator is out.
The food is not well steamed or
cooked.
Note: If the fault still persists after the examination above, contact service center or dealer.
a. Power failure;
b. Power cable is not inserted into the power socket;
c. Power socket is OF;
d. Product's power cable plug is not securely inserted into the
power connector of the lunchbox; or
e. The product is protecting itself from working without water.
a. Added too much or little water.
b. The operating time is wrongly set.
Possible cause
13