Troubleshooting; Assembly; Set Up And Operation - Kreg KMA4500 Benutzerhandbuch

Troubleshooting

Assembly

Problem
The guide rails do not connect snugly.
The rails are misaligned.

Set Up and Operation

Problem
The handle is too far away to clamp to
smaller/narrow material.
The guide rail is not long enough for larger
pieces.
The guide rails slips and the clamp does
not hold to the material snugly.
The cut is not accurate to the line.
The distance of the indicator arm does not
reach to the blade for offset.
The material warps under the clamp
pressure causing the guide not to sit flat.
The guide will not sit flat on the material
because the clamp pads touch the ground.
The guide moves or shifts during use.
Routing dadoes and rabbets do not align
to my measurements.
The saw gets hard to push, burning
occurs, or the saw walks away from the
guide.
The jigsaw vibrates the clamp loose.
The clamp does not hold to the material.
Solution
Ensure the top and base plate connectors with
set screws are secured tight.
Use a level or straightedge to align.
Solution
Remove a section of guide rail and use only one
section. Reinstall the handle.
Purchase the Extension or XL version of this
product.
Ensure the guide rail sits flat and that the cutline
indicator arms sit flat to the material. When
setting the clamp do not pull upwards.
Recalibrate the tool.
Reinstall indicator arm facing the other way in
clamp pads and recalibrate.
It is recommended to fully support the workpiece
and cutoff with 2x4s or with 2"-thick (50 mm) rigid
foam insulation laid flat on the floor.
Clamp pads are designed for material thickness
3/4" or greater for on the ground cutting. For
thinner materials such as 1/2" or less, elevate the
workpiece to ensure the pads are off the ground.
Ensure you have applied adequate clamping
pressure when positioning the tool.
Recalibrate the indicator arms considering the bit
type and diameter.
The saw blade may not be square to the saw
base plate. See the saw owner's manual.
Check to ensure oscillating mode on your jigsaw
is turned off.
Check the material for square edges.
15