Operation - Kreg KMA4500 Benutzerhandbuch

Operation

WARNING Avoid awkward hand positions where a sudden slip could cause contact
with the blade or bit.
This procedure applies to all models numbers covered in this manual and can be
executed using a circular saw, jigsaw, or trim router.
1 Measure and Mark Your Material
Measure and mark on both sides of the material edge.
Note Make your mark lines at the edge of the material to your desired
measurements. You will align the flat face of the cutline indicator arms to these
marks moving forward.
Note Mark your cutoff (waste) portion of the board (marked with an X in the
illustration below).
11