Maintenance / Cleaning - Laserworld EL-400 RG Bedienungsanleitung

Manual / Bedienungsanleitung: EL-400 RG / EL-700 GB
The address is the sum of all activated numbers, see the following example settings (the white
rectangle represents the position of the switch)
Addr switch
1
17
The laser uses 9 DMX channels, so make sure that the next device uses an address that doesn't
overlap with this range. E.g. when using address 1, make sure the next device uses at least address
number 10.
Channel
1
2
3
4
5
6
7
8
9
Please note, that not all effect channels work with every pattern.

Maintenance / cleaning

Always disconnect from the mains when the device is not in use or before cleaning it.
Open the device by removing screws along the top cover (front and back), remove the top cover.
Remove any deposits of dust, especially at the fan. Check for condensed fog fluid inside. If so,
clean and rearrange the position of laser and/or hazer.
noticeable around the beam or an unusual high amount of diffuse light can be seen inside the
device. Clean the mirrors with window cleaner and a paper towel.
Never look directly into the light source. Always disconnect from the mains when the
device is not in use or before cleaning it.
4 8
5 16
function
mode: 0-63 Laser off; 64-127 sound mode; 128-191,
automatic mode; 192-255 DMX mode
Patterns
Animation (not with all patterns)
strobe (with increasing speed)
Point speed
horizontal movement
vertical movement
Colour: 1-101 green and red; 102-199 red; 200-255 green
Reset: above 200 (shortly)
9 256
10 Mode switch
:
addr switch
65
113
Mirrors need cleaning when a "halo" is
Page / Seite 5 of / von 10
Version / Stand: Jun-13