Troubleshooting; Technical Data - SPEEDLINK POWERSTIXX 2.1 Bedienungsanleitung

If there are no batteries in the remote control, note that the spring of
D
the contact plate inside the battery compartment points downwards.
GB 3. Remove old batteries and insert new batteries in the battery
compartment as indicated by the markings (see point 3 of
F
diagram).
4. Fit the battery compartment into the remote control. Make sure
E
the + and - markings and the function buttons of the remote control
all point upwards (see right-hand diagrams)!
I
5. Replace the screw and fasten the battery compartment.
Notes about batteries:
• Keep batteries out of reach of children.
• Do not mix old and new batteries, or batteries of different types.
Follow manufacturer's instructions on battery use.
• Remove old, weak or worn-out batteries promptly.
• Always recycle or dispose of used batteries in accordance with local
regulations.

4. Troubleshooting

The system is correctly connected but the LED on the front of the
subwoofer does not light when switching on.
Make sure you have moved the switch on the back of the system to ON.
No sound
Check you have correctly connected the system to your sound source
and that you have selected the correct sound source. Use the Input
button on the remote control to switch between the connected sound
sources (Input 1 and 2) (see section 2).

5. Technical data

Model no.: SL-8225
Output, (RMS)
Frequency range
S/N ratio
Impedance (Ohm)
Dimensions (WxHxD)
Power supply
Downloaded from www.Manualslib.com
Subwoofer
30 W
5.25"
40-150 Hz
72 dB
4
310x319.5x360 mm
manuals search engine
Satellites
2x6 W
2x1" magnetically
shielded
150 Hz.-20 kHz
68 dB
4
100x245.5x100 mm
230V
12