Troubleshooting - babymoov Turbo Pure Benutzungsanleitung

Descaling
Mineral residue may be deposited on the heating part after a few uses. To prevent excessive scaling, clean the surface with a
damp cloth after each use. After 50 sterilisation and/or drying cycles, the droplet icon will turn blue.
Proceed as follows:
1. Remove the water remaining in the tank with a sponge or a cloth.
2. Mix 50 ml of hot water with 105 ml of white vinegar and pour the solution into the tank.
3. Leave to stand for 2 hours or more if required, then empty the tank. Also leave the steam nozzles to soak in the same solution.
4. Run a sterilisation cycle to remove any white vinegar odour or residue.
5. Once the cycle is complete, press "OK" and hold for 5 seconds to reset. The blue droplet icon will turn off. If you do not press
"OK" for 5 seconds - even though the unit is switched off and on again - the blue droplet icon turns on again.
• If the water level is too low during a cycle, in addition to the need to descale, the orange droplet will turn on first. In this case,
follow the procedure described above for low water level problems. When you switch the appliance on again, the orange
droplet will disappear but the blue droplet will turn on. Then perform the descaling procedure and operation described above.
• Discoloured marks may appear following cleaning using white vinegar, but are perfectly safe.
• If limescale residue appears on the product before the droplet turns blue, you can also perform the descaling procedure
explained above.
PROBLEMS
Low water level: the
droplet turns on in a
23 00 23 00
steady orange colour
and is accompanied by 5
quick warning beeps.
Error code (4 digits + 5
quick warning beeps):
ER R4
- ERR1
- ERR2
- ERR3
- ERR4
Appliance does not start
Presence of white areas or marks on the
heating unit, or any other part of
the steriliser.
Bottles come out with stains.
Sterilisation process is too long or
too short.
18 TURBO PURE BABY BOTTLE STERILISER & DRYER • Instructions for use

TROUBLESHOOTING

POSSIBLE CAUSES
The screen displays the time at which the cycle
stopped, indicating that the program did not shut
down correctly due to the low water level in the tank.
Error code indicating a malfunction
Incorrect power outlet voltage.
Appliance is not plugged in correctly.
Low water level.
Limescale accumulation is normal and may occur
at a quicker rate in hard water areas.
Unsuitable water level in tank.
SOLUTION
∙ Press "ON/OFF" to switch off the appliance and then
wait 10 minutes for the appliance to cool down.
∙ Press "ON/OFF" to turn the appliance back on, pour
105 ml of water into the tank of the appliance and run
a new cycle.
∙ If the appliance has not cooled down suffi ciently,
the droplet icon will turn orange when you press
"OK" to confi rm the "STERILISATION + DRYING" or
"STERILISATION" program. In this case, repeat
the operations.
∙ Please contact our after-sales service department.
∙ Check that the appliance is plugged into a mains
socket (230 V).
∙ Check that the appliance is plugged in by pressing
ON/OFF, before initiating the start-up phase.
∙ Check the water level in the heating unit. Add water if
required up to the symbol
∙ Use distilled water.
∙ Descale the appliance regularly by referring to the
"Descaling" section of the instructions for use.
∙ Check that you have poured the correct amount of
water (105 ml) into the heating unit. Adapt the amount
if required.
and restart.