Technical Specifications; Before Using For The First Time - babymoov Turbo Pure Benutzungsanleitung

THANK YOU FOR CHOOSING THE TURBO PURE BABY BOTTLE STERILISER & DRYER
This revolutionary baby bottle steriliser and dryer removes 99% of bacteria and pollutants found in air.
• Input: 220 – 240 VAC, 50-60 Hz.
• Sterilisation power: 600 W.
• Drying power: 125 W.

BEFORE USING FOR THE FIRST TIME

- Wipe the product with a damp cloth (except the electric base).
- Run a full empty sterilisation cycle before using for the first time.
Caution: never immerse the electric base in water
PREPARATION AND USE
Before placing the products in the steriliser, make sure that they are empty, clean and rinsed in clean water.
IMPORTANT: all products to be sterilised must be capable of withstanding temperatures of up to 100°C or 212°F.
• Quick start
For your safety, we recommend that you always read the instructions in their entirety before using the steriliser for the first
time. The 3 steps to carry out a quick start procedure are described below:
- Pour 105 ml of distilled or soft water into the tank.
- Fill the steriliser with your products.
- Select the desired program.
• Filling with water
Fill the water tank with 105 ml of distilled water.
Use the cup included in the product to measure the right amount of water. Fill the cup completely.
The water should reach the symbol
Always respect the 105 ml. Otherwise, it may affect sterilization or drying performance.
• Arranging objects
Turbo Pure is suitable for use with a wide variety of products such as breast pumps, baby food jars, oral syringes and many more!
- Shake off excess water from the bottles. Otherwise, the drying time required will increase.
- Arrange the products, allowing sufficient air to circulate between them.
- Ensure that the bottles are placed upside-down, the nozzles must be placed inside the bottles.
• Operating mode selection
- Plug in the appliance.
- Press ON/OFF to switch on the appliance.
The appliance is then set to READY mode (the STERILISATION, DRYING and STERILISATION + DRYING buttons turn on).
- Press the desired function (STERILISATION, DRYING or STERILISATION + DRYING) and the button will turn on.
The timer will turn on with the corresponding time.
- After pressing the button matching the required function, you can change function simply by pressing another function.
Adapt the drying cycle according to:
- the temperature in the room: for colder temperatures, the drying time required will increase.
- the humidity level in the room: for higher humidity levels, the drying time required will increase.
- the materials of the bottles and accessories: if not made of glass, the drying time required will increase.
- the loading of the steriliser: for heavier loads, the drying time required will increase.
Low water level:
- If water is low, the droplet icon
in less than 8 minutes. This means that the cycle may not have had sufficient time to kill all bacteria. To turn it off, please
refer to the "TROUBLESHOOTING" section.
TURBO PURE BABY BOTTLE STERILISER & DRYER • Instructions for use
Turbo Pure is produced using 100 % BPA-free materials.

TECHNICAL SPECIFICATIONS

.
will turn orange. The appliance will emit a sound to indicate that sterilisation was completed
• Sterilisation time: 8 minutes.
• Drying time: 30, 45 and 60 minutes.
• Descale and low water level alert.
15