Omnitronic SMP-300 Bedienungsanleitung

USER MANUAL
STUDIO MICROPHONE SET
Professional microphone set for studio recording and live applications
The SMP-300 true condenser microphone set was designed for professional studio recording and live
applications. The microphones operate on 48 V phantom power.
Set consisting of two instrument microphones with interchangeable omnidirectional and
cardiodid capsules, and a cardioid vocal microphone with medium-sized silver-plated diaphragm
Perfect for drums (overhead, snare, HiHat) acoustic-guitar or piano
Low-noise transformerless FET input eliminates low frequency distortion
Cardioid pickup pattern for effective feedback elimination
All microphones with balanced XLR output
Safety Instructions
Maintenance and service operations are only to be carried out by authorized dealers. Damage,
caused by manual modifications on these devices are not subject to warranty. If the microphones are
used for other purposes than originally intended or if they are not correctly connected, the products
may suffer damages and the guarantee becomes void.
Protect the devices against humidity and heat. The ambient temperature must always be between -5°
C and +45° C. The relative humidity must not exceed 50 % with an ambient temperature of 45° C.
Setting into Operation
For the instrument microphones, select the desired microphone capsules and screw them onto the
microphone body.
Screw the shock mounts on your microphone stands and insert the microphones from above.
Connect the microphones via balanced microphone cables with 3-pin XLR plugs to the XLR
microphone inputs equipped with +48 V phantom power of your audio unit (e.g. mixing console).
For voice recordings, use the supplied windshields to protect the capsules from moisture.
Cleaning and Maintenance
For cleaning the microphones only use a soft lint-free and moistened cloth. Make sure not to allow any
water to enter the devices and never use any solvent cleansers.
© Copyright
Nachdruck verboten!
Reproduction prohibited!
Delivery Includes
Technical Specifications
Vocal microphone
Type: ...............................Condenser
Polar pattern: ...................Cardioid
Frequency range: ............20 - 20,000 Hz
Sensitivity at 1 kHz: .........14 mV/Pa; -40 dBu
Impedance: ....................200 W
Max. SPL: ........................140 dB
Instrument microphones
Type: ...............................Condenser
Polar pattern: ...................Omnidir., Cardioid
Frequency range: ............30 Hz - 20,000 Hz
Sensitivity at 1 kHz: ......... -40 dBu
vocal microphone: frequency response (cardioid)
instrument microphones: frequency response (cardioid)
instrument microphones: frequency response (omnidirectional)
Please note: Every information is subject to change without prior notice. 10.05.2007 ©
SMP-300
2 instrument microphones with shock
mount, windshield and interchangeable
omnidirectional and cardiodid capsules
1 vocal microphone with medium-sized
diaphragm, shock mount and windshield
Foam-lined carrying box
S/N ratio: ..........................76 dB
Equivalent SPL: ...............22 dBA
Power supply: ...................48 V DC phantom power
Connection: .....................3-pin XLR, balanced
Dimensions (LxWxH):.......152 x 45 mm
Weight: .............................360 g
Output impedance:...........200 W
Equivalent SPL: ................<22 dBA
Power supply: ...................48 V DC phantom power
Connection: .....................3-pin XLR, balanced
polar pattern (cardioid) at 1 kHz
polar pattern (cardioid) at 1 kHz
polar pattern (ominidir.) at 1 kHz
13030460_V_1_1.DOC
www.omnitronic.com