HP OneLam 400 A4 Bedienungsanleitung Seite 26

EN
Cleaning the Transport Rollers
Adhesive residues and other deposits on the rollers can impair the lamination result. Remove
these at regular intervals and whenever the lamination result is not as good as expected.
1 Activate the laminator so that it is ready to operate.
2 Press the "Operating mode" button several times until you have selected the required pouch
thickness (125Mic || 75Mic/80Mic).
You can select any pouch thickness. Check that the Status LED is flashing GREEN. When the
warm-up phase has elapsed, the Status LED lights up GREEN continuously and the transport
rollers can be cleaned.
Caution!
Risk of burns through hot machine surface!
The laminator heats up during hot lamination. Do not touch the device surface during
operation.
3 Fold a sheet of paper and feed it into the infeed (rear) of the laminator with the folded edge
first and keeping it straight.
Caution!
Risk of burns through hot residual adhesive.
The residual adhesive on the paper discharged is very hot. Only remove the ejected paper
holding it at the cooled end.
The paper is discharged on the output side (front) with the residual adhesive stuck to it.
4 Repeat the process until no further residual adhesive is on the paper.
5 Switch the laminator off.
Î The transport rollers of the laminator have been cleaned.
- 26 -