Use - Casselin CCBM2V Handbuch

ELECTRICAL HAZARD
Risk from electrical current!
In case of improper installation, the device can be dangerous and cause injury. Before installation, check the
power system data. Connect the device only when there is compliance. The unit should be unpacked and
checked fully before connecting by a professional.

5.2 Use

WARNING
The establishment of the installation of the device and maintenance must be performed only by professionals.
• Do not leave the unit without monitor.
• During use, your hands should be dry.
• Do not move or tilt the device during operation.
MANUAL
COMMISSIONING
The unit must be completely removed from its packaging. All guards must be completely removed.
Place the machine upright on a solid, flat surface.
Never put the bath on a flammable surface.
Do not install this device near open fires or other heating appliances.
The electric cable must be protected at least 16 amperes. The device must be plugged directly into a wall
outlet. Using a power strip will crack up the device.
Clean and rinse the unit before the first use.
USE
Filling the water tank up to the level indicated Max inside the tray.
The water level must not be lower than the level Min.
Connect device, once connected, press the start-up switch green.
Turn the temperature control knob.
When the selected temperature is reached, the bright orange light goes out.
When the temperature drops, the appliance starts to heat up and the red LED lights up again.
Never operate the appliance without water in the container.
NOTE
The device has a security system in case of overheating. Upon activation, disconnect the device and allow it
to cool. If this protection system will start regularly, it is imperative to contact your dealer.
After automatic shutdown, the unit may be commissioned only by pressing the reset button on the unit's back
for this, wait until the temperature drops, press the Reset button.
EN