Caliber CAM201 Schnellstartanleitung

LICENSE PLATE CAMERA AND RADAR
- Input voltage DC 9V - 16V
- Power consumption: <3W
- Wireless power transmitting: 10dBm
- Ultrasonic frequency: 40kHz
- Operating temperature: -20ºC - +70ºC
- Horizontal definition 380 lines
- Min. illumination <3 Lux
- Luminance signal & SNR = 450dB
- View angle: >140º
- Video output signal: PAL (2.4G RF transmitting)
- Radar signal transmitted by 2.4G RF radar frequency: 40kHz
- Radar detecting distance: 3m - 2,5m
- Radar detecting angle: H 60ºC / V 120ºC
- Sensitivity: PV=1.2m
- Tolerance on detecting distance: 0,05m
- Waterproof IP67
First choose the mounting position, camera on top of the license
plate or camera below the license plate.
Drill 2 srew holes with a
4,5mm diam. drill and drill a
10mm hole for the power
wires. Place the product
in place and tighten up the
screws. Connect the red
wire to the positive wire
(+) of the reversing light,
connect the black wire to
negative ground (-)
The camera can be moved down or up to the suitable angle
EN | CAM201 QUICK START GUIDE
3,5" TFT DISPLAY
- Input voltage: DC 9V - 16V
- Power consumption: <3W
- Wireless receive sensitivity: -80dBm
- Operating temperature: -20ºC - + 70ºC
- Operating humidity: <95%
- Automatic identification with license plated camera and radar
- Automatic display of the image of the rearview camera
- Automatic distance indication of sensors
- Alert with image, distance, direction and sound.
- Adjustable brightness and contrast
- NTSC/PAL type self-test
ESC key
- exit menu
- Identifiy: after installation hold ESC button
>3 sec. to match the adress code of the radar of
camera/sensors
Menu key:
Open menu, press repeatedly to select menu items
+/- keys
For changing numeric value down/up
- brightness/contrast 0-100
- volume 0-5
- distance calibration 0,1-0,5m
- volume adjustment (if menu is not open)
Calibration
First identify the unit: Put the ignition key to acc and then put the
car in reverse to make the camera and radar work. Now hold ESC
for a few seconds to match the ID.
Now calibrate the distance between the sensors and the bumper.
- Measure the distance
- Press menu to choose calibration function
- Press + or - to set the distance (0,1 to 0,5m)
Please note:
This is only a parking aid.Any damage or accidents caused are under the
responsability of the driver. No claims can be made to the manufacturer or
distributor of this product.
Occasionaly some dark spots or highlights may occur on the display.This
is a common phenomenon in active matrix display technology, and is not a
malfunction.Any disassembly or modification may lead to damage and void
warranty.
ESC key
+ key
- key
Menu key