Switching On The Wft400; Configuration; Connecting To The Wifi Network; Internet Access Via The Wan Port - Teleco WFT400 Installations- Und Bedienungsanleitung

6.

SWITCHING ON THE WFT400

1. Press and hold the ON/OFF button for 3 sec-
onds to switch off the router.
2. Insert the SIM CARD, as shown in
3. Connect the power cable.
4. Press the ON/OFF button and wait for the
router to connect to the mobile phone net-
work of the operator associated with the SIM
EN
CARD.
Insert or remove the SIM CARD with the
router switched off. If the router is on,
the SIM CARD may be damaged and
become unusable.
The LEDs on the front panel provide indications
on the operational status of the router.
LED Status
Power supply
SYS On: Power supply present
Off: Power supply not present
RF Indication of the RF signal reception strength
On: WiFi enabled
WiFi Off: WiFi not enabled
Flashing: attempting WPS connection
On: Concrete LAN or PC connection
ETH Off: Not connected with LAN or PC network
Flashing: Data transfer
Wireless connection status indicator
On: Connected to the network
NET
Off: Not connected to the network
Flashing: data transfer
Tab. 1 - WFT400 LED status indicators
- 8 -

6.1 Configuration

Configure the router using the Graphical User In-
terface (GUI) accessible via web browser by typ-
ing the address http://192.168.1.1.
Fig. 2
Use the following login credentials to access the
configuration panel:
Username: admin
Password: admin
All the information for the GUI connection, the
user address, password and IP router is displayed
on a label on the back of the router.

6.2 Connecting to the WiFi network

The login credentials for the router WiFi network
are:
SSID: WFT400-xxxx;
Password: 12345678.

6.3 Internet access via the WAN port

1. Connect the WAN port on the back of the rout-
2. Configure the access parameters for the PP-
WFT400
Translation of the original instructions
Once you have entered, change the pass-
word to prevent unauthorized access.
Change the SSID and WiFi network ac-
cess password using the GUI, in order to
prevent unauthorized access.
er to the Ethernet socket via an Ethernet ca-
ble with an RJ45 connector.
PoE/Static/DHCP internet network.
Rev.001