Changing The Volume; Setting The Ringing Melody - Me Bell-270 Rx Anleitung

270 RX beeps 4 times directly when the CODE button is pressed, 4 different
codes have already been learned and the internal memory is full. To clear
the memory, follow the procedure described in FACTORY SETTINGS.

CHANGING THE VOLUME

The volume of the Bell-270 RX can be adjusted in 5 steps using the two
buttons ( 3 ) + and -.
CHANGING THE COLOUR OF THE ILLUMINATED RING
To change the colour of the illuminated ring, press the MODE button ( 2 ) on
the Bell-270 RX once. The light ring will flash the next colour and play a
melody.

SETTING THE RINGING MELODY

The ringing melody is set by the transmitter. Refer to the transmitter manual
to change the melody.
CHANGE CODING
If the Bell-270 RX plays a melody unintentionally, a similar device with the
same code is probably transmitting in the neighbourhood. In this case, reset
the Bell-270 RX to factory settings and change the transmitter's code, refer
15
BELL-270 RX
EN