Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operating Instructions
LED Lamp
Item No. 2290784
Intended use
The product is an LED lamp
It is intended for indoor use only. Contact with
moisture must be avoided under all circum-
stances.
For safety and approval purposes, you must
not rebuild and/or modify this product. If you
use the product for purposes other than those
described above, the product may be dam-
aged. In addition, improper use can result in
short circuits, fires, electric shocks or other
hazards. Read the instructions carefully and
store them in a safe place. Make this product
available to third parties only together with its
operating instructions.
This product complies with the statutory na-
tional and European requirements. All compa-
ny names and product names are trademarks
of their respective owners. All rights reserved.
Delivery content
• LED lamp
• 4 x mounting screws
(M4 x 16 mm)
• Operating instructions
Up-to-date operating instructions
Download the latest operating instructions at
www.conrad.com/downloads or scan the QR
code shown. Follow the instructions on the
website.
Explanation of symbols
The symbol with the lightning in the
triangle is used if there is a risk to
your health, e.g. due to an electric
shock.
The symbol with the exclamation
mark in the triangle is used to indi-
cate important information in these
operating instructions. Always read
this information carefully.
This device was constructed ac-
cording to protection class III. Pro-
tection class III includes electrical
devices with a low voltage power
supply (< 50 volts) using a safety
transformer or batteries/recharge-
able batteries/solar energy etc. De-
vices in protection class III have no
connection for protective insulation
- they must not be connected to the
protective earth.
Safety instructions
Read the operating instructions
carefully and especially observe
the safety information. If you do
not follow the safety instructions
and information on proper han-
dling in this manual, we assume
no liability for any resulting per-
sonal injury or damage to prop-
erty. Such cases will invalidate
the warranty/guarantee.
a) General information
• The device is not a toy. Keep it out of the
reach of children and pets.
• Do not leave packaging material lying
around carelessly. This may become dan-
gerous playing material for children.
• Protect the appliance from extreme tem-
peratures, direct sunlight, strong jolts,
high humidity, moisture, flammable gases,
steam and solvents.
• Do not place the product under any me-
chanical stress.
• If it is no longer possible to operate the
product safely, take it out of operation and
protect it from any accidental use. Safe
operation can no longer be guaranteed if
the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in
poor ambient conditions or
- has been subjected to any serious trans-
port-related stresses.
• Please handle the product carefully. Jolts,
impacts or a fall even from a low height can
damage the product.
• Consult an expert when in doubt about the
operation, safety or connection of the ap-
pliance.
• Maintenance, modifications and repairs
must only be completed by a technician or
an authorised repair centre.
• If you have questions which remain un-
answered by these operating instructions,
contact our technical support service or
other technical personnel.
b) LED light
• Attention, LED light:
- Do not look directly into the LED light!
- Do not look into the beam directly or with
optical instruments!
c) Installation
• Contact a specialist if you have any doubts
relating to installation.
• The product is only intended for connection
to a 11.5 to 13.6 V/DC supply system.
• Do not install this system in a damp or wet
location.
Connecting the power supply
Important
Route cables in such a way that they do not get jammed or touch sharp edges. Use
rubber grommets when passing wire through metal plates and panels.
Polarity
RED
BLACK
Care and cleaning
• Disconnect the product from the power supply before each cleaning.
• Do not use any aggressive cleaning agents, rubbing alcohol or other chemical solutions as
they can cause damage to the housing and malfunctioning.
• Clean the product with a dry, fibre-free cloth.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the house-
hold waste. At the end of its service life, dispose of the product in accordance with
applicable regulatory guidelines.
You thus fulfill your statutory obligations and contribute to the protection of the envi-
ronment.
Technical data
Input voltage / current ................... 11.5 to 13.6 V/DC, 0.45 A
Rating ........................................... max. 6.3 W
Insulation resistance ..................... 500 V/DC Min. 100 MΩ
LED type ....................................... 0.5 W x 18 pcs
CCT .............................................. 5600 K ±20 %
Luminous flux ............................... 457 Lm ±20 %
Illuminance ................................... 380 Lux ±20 %
Housing color ................................ White
Protection class ............................ III
Material ......................................... Lens: PP
Base: ABS
Operating/Storage conditions ....... -20 to +60 ºC, ≤ 75 % RH (non-condensing)
Dimensions (L x W x H) ................ 410 x 65 x 35 mm
Weight .......................................... 177 g
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com). All rights in-
cluding translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication
represent the technical status at the time of printing.
Copyright 2021 by Conrad Electronic SE.
*2290784_v2_0121_02_dh_m_en
Werbung
