Trouble Analysis - MaxxHome 20501 Bedienungsanleitung

TROUBLE ANALYSIS

Before you send out the heater for repair please check the following points first, they are not faults:
PROBLEM
Odor, smoke or spark omitted by the first use
Ignite when he first use or when the fuel was
used out, strange sounds, odor, white smoke
Strange sound while igniting or flameout
Fire appears out of the outlet while igniting.
Sparkle
Problem of "E1" and "E2" shown on
the LCD display of diesel heater
TROUBLE SHOOTING GUIDE--REASON AND SOLUTION
trouble Heater
does
not start
No power ●
Power ●
breakdown
Low voltage
Frequency
not proper
The air hole
blocked
Filter
blocked
Fuel exhausted
Water is mixed
in the tank
The quality of
fuel is bad
Fuel drain screw
isn't tightened
Others ●
REASON
It is normal. Because at the beginning
there are air and dust mixed in the burning.
Wait for some time they will disappear.
Air is mixed in the pipe, the phenomenon will
disappear when the air in the pipe was
pressed out.
The metal parts of the heater expand and
contract cause the noises. normal
Fuel and air of last time were left in the oil
pipe of the nozzle, so the air and fuel are
not proper mixed, the burning isn't continuous.
Sparkle is caused by the left carbon powder,
is also normal
"E1" means oil has run out.
"E2' means temperature sensor is broken.
Flame Flame Fuel
does goesout leaks
not while
ignite burning
●
●
●
●
● ●
Smoke Fire
or dust from
outlet
● ●
● ●
● ●
● ●
● ●
●
● ● ●
solution
Make sure the
power is proper
connected
When the power
recovers, operate
the heater again
Resolve the problems
which cause the
voltage gets low
Use the defined
frequency on
the label
Clean the hole on
the fuel tank cap
Check and
replace the filter
Fill the tank
Clean the fuel
tank
Clean the fuel
tanks and fill fresh
kerosene or diesel
Tighten the screw
Contact your
dealer or service
personnel