Alignment / Fine Adjustment; Technical Data - Balluff BAM PC-LG-037-Serie Betriebsanleitung

BAM PC-LG-037/038-...
Protective housing for safety light curtains
2
Assembly (continued)
2.4

Alignment / fine adjustment

For correct alignment of the BLG 4A light
curtain be sure to have read and
understood the user's guide for the BLG 4A
safety light curtains.
Note possible differences in the overall system
when using the protective housing (see section
Technical data on page 10).
Depending on which slotted holes are used in the holder,
the protective housing can be axially rotated by up to 20°
or 30° (see Fig. 3-1 on page 10). This allows slight
deviations between the emitter and receiver to be
compensated.
1. Slightly loosen the three fastening screws (e-1) on both
holders (e).
2. Rotate the entire unit to the desired orientation (see
Fig. 2-11).
Fig. 2-11: Fine adjustment
3. Tighten the three fastening screws (e-1) on both
holders (e).
www.balluff.com english 9