Check The Scope Of Delivery - Parkside 326376 Montage-Und Sicherheitshinweise

• Only exert pressure on the bench-top or
workpiece in a vertical direction. The bench
may tip if angled or lateral pressure is applied.
• Do not stand on the struts to stabilize the
bench.
• Do not allow the bench to enter into the hands
of children. Only allow children to use the
bench when supervised.
• Store the bench in a dry location.
• Do not expose the bench to rain.
Pay attention to residual risks
There are a number of residual risks even when
the product is used correctly. These are:
• Clamping of body parts in moving parts
• Damage to the workpiece caused by too much
clamping pressure

Check the scope of delivery

Check the scope of delivery for completeness
and good condition.
If parts are missing or in the event of damages:
Do not assemble the workbench and vice and do
not use. Put in a complaint with your dealer.
The scope of the delivery consists of:
Figure A
No. Quantity Component
1 4 pieces Plastic feet for legs
2 4 pieces Vice jaws
3 1 piece Leg (rear left)
4 2 pieces Legs (front right and front left)
5 1 piece Leg (rear right)
6 4 pieces Installation brackets for the spindle
casing
7 2 pieces Spindle casing with crank
8 2 pieces Cross-pieces for legs
9 1 piece Clamping plate (rear)
10 1 piece Clamping plate (front)
24
11 1 piece Spanner wrench NW 10/13 mm
12 16 pieces Universal screws 5 x 15
13 8 sets Slotted/cross-headed screws
(PH 3) M 6 x 32 each with
1 washer and 1 nut (self-tapping)
14 6 sets Hexagonal screws M 8 x 40 each
with 2 washers and 1 nut (self-
tapping)
Assembly
Note: The bench is assembled upside down and
then turned around onto its legs.
Figure B
On both spindle casings:
Remove the nuts and use to assemble
the installation bracket. To do this,
use a 13 mm socket. Tighten the
nut, making sure that the installation
bracket can still be moved a little.
Figure C On both spindle casings:
Remove both screws and use to
assemble the other installation
bracket. Tighten the screws.
Figure D Position both clamping plates with the
underside facing upwards.
The sides with the notches should be
facing one another.
Figure E/F
Assemble the two spindle casings
on the right and left of the clamping
plates.
Figure G-J Assemble the legs. The cropped
ends of the legs must point outwards.
Tighten the nuts sufficiently to ensure
that the legs can still be swiveled.
Figure K Fold the legs out and bring the struts
into position.
Figure L/M Screw the struts to the front legs.
Tighten the nuts sufficiently to ensure
that the screw connections remain
fluid.
Figure N Assemble the cross-pieces. Tighten
the screws.
Figure O Fit the plastic feet in such a way that
the ribbed surfaces form an even
surface.