Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3) Place the draw bar (D, Fig 12&13) into the bottom of the
spindle and tighten it with the supplied spanner.
Fig 11
Fig 12
4) Firmly tighten the arbour nut (N, Fig 14) using the supplied
spanner (S, Fig 15) .
Attention:
Verify correct nut placement.
The nut must have minimum 3mm distance to the end of
spindle nose thread.
Install the cutting tool (see chapter 7.4):
Disengage the spindle rotation lock.
Connect the machine to the power source.
Start the shaper cautiously.
Arbour removal:
The draw bar (D, Fig 12&13) must be removed first.
7.3 Collet installation
Disconnect the machine from the power source.
Remove the arbour ( see chapter 7.2)
Install the collet with nut (Q, Fig 16).
Fig 13
Fig 14
Fig 15
Werbung
Kapitel
Inhaltsverzeichnis
