Screw Holes - ASROCK Z77 Extreme4 Bedienungsanleitung

2. Installation
This is an ATX form factor (12.0" x 8.6", 30.5 x 21.8 cm) motherboard. Before you
install the motherboard, study the configuration of your chassis to ensure that the
motherboard fits into it.

2.1 Screw Holes

Place screws into the holes indicated by circles to secure the motherboard to the
chassis.
2.2 Pre-installation Precautions
Take note of the following precautions before you install motherboard components
or change any motherboard settings.
Downloaded from www.Manualslib.com
Make sure to unplug the power cord before installing or removing the
motherboard. Failure to do so may cause physical injuries to you and
damages to motherboard components.
Do not over-tighten the screws! Doing so may damage the motherboard.
1. Unplug the power cord from the wall socket before touching any
components.
2. To avoid damaging the motherboard's components due to static
electricity, NEVER place your motherboard directly on the carpet
or the like. Also remember to use a grounded wrist strap or touch a
safety grounded object before you handle the components.
3. Hold components by the edges and do not touch the ICs.
4. Whenever you uninstall any component, place it on a grounded anti-
static pad or in the bag that comes with the component.
5. When placing screws into the screw holes to secure the mother-
board to the chassis, please do not over-tighten the screws! Doing
so may damage the motherboard.
Before you install or remove any component, ensure that the power is
switched off or the power cord is detached from the power supply. Failure to do
so may cause severe damage to the motherboard, peripherals, and/or
components.
ASRock Z77 Extreme4 Motherboard
manuals search engine
13