Werbung
SDA200 LOUDSPEAKER PANEL
1. DESCRIPTION
The SDA200 loudspeaker panel has a high-performance elliptical transducer
for broadcasting the sound programme tuned and amplified by the receiver
module.
2. CONNECTIONS
Two lengths of cable are secured to the loudspeaker for easy connection to
the receiver module. The red lead is connected to the positive terminal of
the loudspeaker while the white lead is connected to the negative terminal.
WARNING!
In order to ensure the necessary compliance with the safety regulations in
force, as well as perfect functioning of the whole RF distribution system, the
system must be set up and the various modules must be installed by qualified
technical personnel. Special attention should be paid when connecting the
equipment to the mains power supply. The power supply transformers must
only be connected to the mains with the system powered down . Any
activities carried on inside the distribution boxes and the various modules
can entail the risk of electric shocks. It is therefore necessary to take all the
appropriate precautions.
PASO S.p.A. will not accept any liability for damage to property and/or
personal injury due to failure to comply with the above recommendations.
The various modules of the SD200 system have to be installed inside model
27/901 boxes for flush mounting.
SDA200-T - SDA200-T/117
LOUDSPEAKER PANEL WITH TRANSFORMER
3. DESCRIPTION
In addition to a high-performance elliptical transducer for broadcasting the
sound programme, the SDA200-T (SDA200-T/117) loudspeaker panel
includes a power supply transformer (220 V / 9.5 V or 117 V / 9.5 V for the
SDA200-T/117 version) for supplying power to the receiver module.
4. CONNECTIONS
There are two lengths of cable attached to the loudspeaker: the red lead is
connected to the positive terminal of the loudspeaker while the white one is
connected to the negative terminal. There are four leads coming out of the
power supply transformer. The two white leads (primary winding) are for
connection to the mains while the two red leads (secondary winding) are for
connection to the power supply terminals of the receiver module.
5. SPARE PARTS
Front plate ........................................................................................ 41/490
Netting ................................................................................... 36/1831-VGS
Loudspeaker (3 W / 8 Ω) ..................................................................... AT80
6. ACCESSORIES
• SDT100
• SDT100/117
• 27/901
Power supply transformer 220 V / 9.5 V
Power supply transformer 117 V / 9.5 V
Flush mounting box
SD200 SYSTEM
SDA200
SDA200-T
SDA200-T/117
3
Werbung
