Battery Installation - Innokin iTaste SVD Gebrauchsanleitung

Battery Installation

Short Telescopic tube
Battery negative (-) cap
Long Telescopic tube
There are two telescopic tubes available for the iTaste SVD; short tube
supports 18350 batteries and long tube supports IMR 18350(2), 18500
and 18650 batteries. You also can use 2 IMR high drain 18350 batteries
at the same time, which will give you the full arrange of voltages/
Wattages and proper power needed to use the device.
Please install a proper battery before operation. Screw the battery
negative (-) cap off the telescopic tube, then insert battery into the
telescopic tube with the negative (-) end of battery in first and the
positive (+) end out towards the battery negative (-) Cap.
Note: Before you make a switch between one battery and two
batteries, please hold the " " button for 5 seconds to release the
remaining capacity in the mainboard. (when you make a switch from
one battery to two batteries, the mainboard will keep the one battery'
settings if you haven't released the remaining capacity; and vice versa.)
MANUEL D'USAGE
FR
EN-5
Downloaded from www.Manualslib.com manuals search engine