Bestway 62069 Bedienungsanleitung

1. Parts List
No. Description
P6095 Motor Mount Board
P6096 Bent Tube
P6097 Straight Tube
P6098 U-screw
P6097
2. Assembly Instruction
A
FIG 1
FIG 2
FIG 3
S-S-005415/21.0X28.5cm/62069(马达架说明书)JS-YF-2016-B-11227/英语
OWNER'S MANUAL
MOTOR MOUNT KIT ASSEMBLY
MODEL No. 62069
Qty No. Description
1 P6106 Tube Clamp
2 P6107 Board Clamp
2 P6108 Star-screw
2 P6109 Star-nut
P6106
P6098
A
B
Step 5:
Tighten all
screws and nuts.
It is important to check all screws
and nuts to make sure they are
secured prior to using.
1
Qty
2
2
P6095
4
4
P6108
P6107
Step 1: Inflate the boat.
Step 2 (FIG 1): On the lower back end (stern) of
the boat, insert the curved end of the Bent Tube
(P6096) through the lower Grommet (A) and attach
a Tube Clamp (P6106). Tighten the Star -screw
(P6108) on the Tube Clamp (P6106) to secure the
curved end of the Bent Tube (P6096) in place.
Use the same procedure for the opposite side.
Step 3 (FIG 2) : Place the Straight Tube (P6097)
with the stoppled end through the upper
Grommet (B). Then insert the smaller end of the
Straight Tube (P6097) into the unbent end of the
Bent Tube (P6096) and fix in place with a
Star-screw (P6108).
Use the same procedure for the opposite side.
Step 4 (FIG 3): To attach the Motor Mount
Board (P6095), place the Board Clamp (P6107)
against the Bent Tube (P6096). Insert the U-screw
(P6098) through the holes on the Board Clamp
(P6107), (the prongs of the U-screw (P6098)
should be facing away from the boat). Place the
Motor Mount Board (P6095) against the Board
Clamp (P6107), lining up the holes on the Motor
Mount Board (P6095) with the U-screw (P6098).
Fix the Motor Mount Board (P6095) into place by
tightening the Star-nuts (P6109) onto the protruding
U-screw (P6098).
Use the same procedure for the opposite side.
P6096
P6109
S-S-005415