Lighting Technologies FREGAT LED Serie Montageanleitung Seite 9

3. Install lightning fixture on bracket-type support or torchere support with a diameter of 48-60
mm until tight, weakened/tightened two wires. Tightening force of wires is no more than 18Hm.
4. For CR luminaires it is possible to install the luminaire controller part.no. 5911000520
Luminaire controller CS LoRa 3.0 (not included in delivery set) or part.no. 2911000080 Luminaire
controller CS LoRa 1.0 (not included in delivery set). To do this remove the cap and connect the
controller in accordance with its installation manual. IMPORTANT! Self-adhesive label with
controller's serial number is included in delivery set of the controller. One label is applied on the
controller, the second label must be placed on the appropriate support on which the luminaire is
installed, at a height of 1,5-2 meters, after cleaning the support material. ATTENTION! Failure to
comply with this paragraph will lead to the inability to identify the serial number of the luminaires'
controller and the inability to address the launch of the lighting control system. Standby losses –
0,6W
WARNING! Installation of the controller is prohibited at the time of rainfall!
5. ATTENTION!
Check tightening and tighten if needed of the mains cable gland's nut during installation.
LUMINAIRE LIFTING AND CARRYING BY MAINS CABLE IS PROHIBITED, doing this may
cause moist protection failure, cable and luminaire's internal circuits damage.
These instructions assume expert knowledge corresponding to a completed professional
education as an electrician.
Overall and installation dimensions, mm
1.
9