General Guidelines - Velleman LPTDX626 Bedienungsanleitung

3. General Guidelines

• This device is a lighting controller for professional use on stage, in discos, theatres, etc. The LPTDX626 should
only be used indoors with an alternating current of max. 230VAC / 50Hz.
• Do not shake the device. Avoid brute force when installing or operating the device.
• Select a location where the device will be protected against extreme heat, moisture and dust.
• Do not use or transport the device under temperatures < 5°C or > 35°C.
• Familiarise yourself with the functions of the device before actually using it. Do not permit operation by unqualified
people. Any damage that may occur will probably be due to unprofessional use of the device.
• Use the original packaging if the device is to be transported.
• Note that all modifications of the device are forbidden for safety reasons.
• Do not remove the serial number sticker from the device as doing so will void the warranty. Only use the device
for its intended purpose. All other uses may lead to short-circuits, burns, electroshocks, lamp explosion, crash,
etc. Using the device in an unauthorised way will void the warranty.
4. Description
a) Front Panel
Fig. 1
1. ON/OFF switch
2. DMX output/input signal socket (5 pin)
3. DMX input (RJ11 phone jack)
4. LED display
b) Back Panel
Fig. 2
9. DMX connector (RJ11 phone jack)
10. DMX input socket (3-pin XLR)
11. DMX output socket (3-pin XLR)
12. Power input terminals (20A single phase)
13. Output terminals (20A for each channel). External automatic circuit breaker is necessary when mounting.
LPTDX626
5. Function buttons
6. Dimming VR of channel 1-6
7. Automatic circuit breaker (channel 1-3)
8. Automatic circuit breaker (channel 4-6)
2 VELLEMAN