Montageanleitung Motorantrieb
Installation Instructions Motor Drive
www.fuhr.de
WWW.FUHR.DE
Das autosafe 833/835(P/PK) * lässt sich durch
Montage eines Motorantriebs zu einem
autotronic 834/836(P/PK) mit motorischer
Entriegelung wie folgt aufwerten:
1. Entfernen Sie die beiden schwarzen Ab-
deckkappen am Schloss-Stulp sowie den
Klebestreifen am Motorantrieb.
2. Setzen Sie den Motorantrieb hinter den
Schloss-Stulp und achten Sie dabei auf
den korrekten Sitz des Federbandes.
3. Befestigen Sie nun die Schrauben und die
Abdeckkappe des Reedkontaktes.
Die Montage des Schlosses in
den Türflügel, die weiteren An-
schlüsse und die abschließende
Funktionsprüfung entnehmen
Sie bitte der Montage-, Bedie-
nungs- und Wartungsanleitung
MBW15, siehe www.fuhr.de.
* Bitte beachten Sie den wichtigen Hinweis auf der
Rückseite.
Referenz/Reference: VNZA0002
The autosafe 833/835(P/PK) * can be up-
graded to an autotronic 834/836(P/PK) with
motorised unlocking by mounting a motor
drive as follows:
1. Remove the two black cover caps on the
lock faceplate and the adhesive strip on
the motor drive.
2. Place the motor drive behind the lock
faceplate and make sure that the steel
tape is correctly seated.
3. Now fasten the screws and the cover cap
of the reed contact.
The assembly of the lock into
the door leaf, the further con-
nections and the final func-
tional test you will find in the
installation, operating and main-
tenance instructions MBW15,
please refer to www.fuhr.de.
* Please note the important advice on the reverse
side.
3 x M4
Federband
Steel tape
Reedkontakt
Reed contact
Abdeckkappe
Cover cap
autosafe
833/835(P/PK)
Art.-Nr./Art.no.
9239843
Grüner Motorstecker
Green motor plug