Technical Specifications - MiWire ROUDEM Benutzerhandbuch

order to gain an unobstructed line to the
mast you connect to.
What the goods are broken when I receive
them?
If you receive broken equipment, please
return it to the dealer where you purchased
the equipment, or contact Customer Support
at kundesupport@miwire.net.
FCC declaration
This equipment has been tested and found
to be compliant with the emissions limits for
a Class B electronic device in accordance
with FCC regulations, section 15. These limits
have been defined in order to provide reaso-
nable protection against harmful interferen-
ce in a residential installation.
The equipment generates, uses and may
radiate radio frequency energy, and it may
cause harmful interference to radio commu-
nicati-ons unless it is installed and used in
accordance with the instructions. However,
there is no guarantee that a specific installa-
tion will be interference-
free. If this equipment causes harmful
interference to radio or TV reception - which
can be tested by switching the equipment
on and off - the user is advised to try and
eliminate the interference as follows:
• Realign or relocate the receiver
• Increase the separation between the
equipment and the receiver
• Connect the equipment to a power
socket on a circuit other than the one to
which the receiver is connected
• Contact your dealer or an experienced
radio/TV technician for assistance
Note:
This product will not charge at tempe-
ratures above 40 °C, so it should not be
charged on a window sill, outdoors, in direct
sunlight, etc.
Warning! Contains Li-lon battery,
must not be opened - must not
be replaced by the user

TECHNICAL SPECIFICATIONS

Interface:
10/100 RJ45 passiv
POE-port /18-48 V,
max. 24 watts, micro
SIM
Data
Ethernet: 10 Mbps
transmission:
(half duplex)
Fast Ethernet: 100
Mbps (half duplex)
WiFi: 300 Mbps
4G Cat 4: 300 Mbps
downlink, 50Mbps
uplink
Network
10Base-T: UTP
medium (cable):
category 3, 4, 5
cable (max. 100 m)
EIA/TIA-568 100 Ω
STP (max. 100 m)
100Baset- T: UTP
category 5, 5a cable
(max. 100 m) EIA/
TIA-568 100 Ω STP
(max. 100 m)
Power supply: External power
supply
On Ethernet (POE)
Input: 100-240VAC,
50/60Hz, Output
48VDC/0.5A
ENVIRONMENT
Certification
Operation temperature
Storage temperature
Operating humidity
Storage humidity
EN
via Power
FCC, CE, RoHS
-20 °C ~ +60 °C
-20°C ~ +80°C
0%-100% RH
0%-100% RH
19