General Device Functions; Now Playing Information - Grundig DTR 7000 Bedienungsanleitung

GENERAL DEVICE FUNCTIONS

On the playing screen, rotate the volume knob
or press » +« / »
adjust the volume. Switch off the sound by press-
ing » « on the remote control.
/ MODE« on the device or on the
Press »
remote control to select modes.
Press »MENU/INFO« to open the menu. Press
again to close the menu and return to playing
screen.
On the menu, rotate the knob or press arrow keys
on the remote control to move along the entries.
Press »OK/SCAN« to confirm; press »ALARM/
BACK« or » « on the remote control to step
back.
Press and hold » /
press » « on the remote control to switch to
standby mode. The time, date and any active
alarm times display on the screen.
Press » « to wake up from standby.
Presets
Number of presets: lnternet Radio: 20 l Podcasts:
20 l Spotify: 10 l DAB+: 40 l FM: 40 To store pre-
set, press and hold »PRESET/BTPAIR« or » «
until the display shows the Save preset screen.
Select one of the presets to save the currently
playing station. Store 1-10 preset stations by
directly pressing and hold numbers
« on the remote control. To play a preset, press
»PRESET/BTPAIR« or » « , then select one of
« on the remote control to
MODE« on the device or
»1...10/0
----------------------------------------------------------
the listed preset stations. When a preset station
is playing, it shows n ( 1, 2 etc) at the bottom of
the screen. Recall 1-10 preset stations by directly
pressing the number keys on the remote control.

Now playing information

While stream/DAB/FM is playing, the screen
shows some information about the station, press
»MENU/INFO« or »INFO« to view.
lnputting Character
As each character is selected, the key is built up
near the top of the display.
There are three options accessible by tuning the
navigate reel back before the first characters
»BACKSPACE«, »OK« and »CANCEL«.
Press »INFO« to move to the »BACKSPACE«
box as a short cut.
When the device is overloaded
The device may process large amount of data
after a period of operation, no matter in which
mode, it will cause the system freeze or malfunc-
tion. Reboot the device if necessary.
First-time Setup
When powering the device on for the first time,
it asks to setup the OSD language. Choose your
language and confirm. It displays information
of privacy policy then. Press »OK/SCAN« to
continue. The Wizard installation assistant then
appears, which guides you through the installa-
tion step by step. Select »YES« and confirm your
selection and launch the setup wizard.
If you select »NO«, the next window will ask
you choose if you want to start the setup wizard
again next time you power the device on.
ENGLISH
27