2.6.9 Service / Maintenance / Repair; Explanation Of The Pictograms On The Machine - Baier Elektrowerkzeuge BDB 835 Original Bedienungsanleitung

2.6.9 Service / Maintenance / Repair

•
If the power tool is dropped or becomes wet,
have it checked.
A possibly damaged power tool is dangerous
and no longer safe to operate. Before using the
power tool again, have it checked by our cus-
tomer service or an authorised service centre of
Maschinenfabrik OTTO BAIER GmbH.
•
Repair and maintenance work may only be
carried out by an authorised workshop of
Maschinenfabrik OTTO BAIER GmbH.
Otherwise, all liability and warranty claims
against Maschinenfabrik OTTO BAIER GmbH
expire.
NOTE
When using new carbon brushes, the machine may
only be operated within the green range for the
first 15 minutes – observe LED display in cap of
the drive unit (BDB 835: Item 6, see Figure
BDB 8325: Item 6, see Figure
•
Ensure that original BAIER spare parts and
original BAIER accessories only are used
when needed.
Original parts are available from authorised
dealers. Use of non original parts can cause
damage to the machine and an increased risk of
accidents.
•
Regular servicing by Maschinenfabrik OTTO
BAIER GmbH or a servicing and repair
company authorised by us is specified.
Many accidents are caused by poorly serviced
and maintained power tools.
1 and
2 ).
2.6.10 Explanation of the pictograms
on the machine
The CE mark on a product means that the
product conforms with all the applicable
European regulations and has been
subjected to the prescribed conformity
assessment procedures.
Protection class I equipment
The machine is insulated in such a way
that it has no exposed metal parts that
could be live in the event of a fault. An
additional safeguard becomes active if the
basic insulation fails.
Environmentally friendly disposal of
waste equipment
Waste equipment contains valuable
recyclable materials which should be
reused or recycled. Batteries, lubricants
and similar materials must not be allowed
to get into the environment.
Therefore, please dispose of waste equip-
ment through suitable collection systems.
Wear hearing protection!
The typical A-weighted sound pressure
level of this power tool is over 85 dB (A)
– wear ear protectors when working with
the tool!
Read the instruction manual!
Before starting any work with or on the
machine, this instruction manual, the
safety instructions and the warnings must
be read through carefully and observed.
| 37 |