Easy Washer EX-1036 PLUS Bedienungsanleitung Seite 35

CONDITIONS FOR STORING THE POWER PACK
1. Detach the power pack from main unit, store it in a dry, cool and well-ventilated
place, protect from direct exposure sunlight.
2. The power pack must be stored in a partial state-of-charge, ideally 50%,
recommended temperature 0°~20°, if it is not regular use, be sure to charge the
battery to approx 50% SOC instead of fully charged at least every 3 months.
3. Ideal environment temperature for use to protect lift span of battery:
Working:
ADD ANTI-FREEZE AS FOLLOWS:
1. Pour approximately 3 liters (1/2 gallon) of RV anti-freeze into tank.
2. Connect high pressure hose, nozzle, and power cord.
3. Turn unit on, squeeze lever until a steady stream of RV anti-freeze in present.
4. Turn unit off. Squeeze nozzle lever to release pressure.
5. Remove and place hose, nozzle and power cord in mesh storage compartments.
USING PRESSURE WASHER AFTER STORING WITH ANTI-FREEZE:
1. Drain RV anti-freeze. (follow steps 1 and 2 from Drain water from system)
2. Run 1 tank of fresh water through system before using and ensure all anti-freeze is
purged from system.
WARNING: USE ONLY RV ANTIFREEZE. ANY OTHER AHTI-FREEZE IS CORROSIVE
AND CAN DAMAGE PUMP AND VOID WARRANTY.
English
Downloaded from www.Manualslib.com
0°C ~40°C; Storage: 0°C ~40°C;
manuals search engine
Charging: 0°C ~35°C
Easy Washer
®
35