Weidmuller WAVE Serie Beipackinformation Seite 20

4292540000_IS_WAVEdata.qxd:429254_IS_WAVEdata.qxd 07.07.201
3. Configuring the device
3.1 Tools
A screwdriver with a 2.5-mm blade is required to set the device,
and to connect the conductors to the terminals.
2
3.2 Open the device
Remove the connector Press the lock lightly
on both sides of the housing to unlock it (1),
remove the upper part of the housing and the
1
1
electronics (2).
3.3 Settings
RS232 assignments (DTE/DCE), transmission speed, operating mode,
data direction control, and terminating resistors are set via the
DIP switches SW1 and SW2/SW3.
3.3.1 RS232/RS485/422 3.3.2 RS232/TTY
SW1
SW1
SW2 SW2
SW3
18