Introduction; Consulting The Use & Maintenance Manual; Symbols And Qualifications Of The Operators; Compliance Certificate - CAMPAGNOLA C1 Gebrauchs- Und Wartungsanweisung

1

- INTRODUCTION

1.1 Consulting the Use & Maintenance Manual
Before working on the equipment, carefully read and understand this Use & Maintenance Manual in order to safeguard the operator
and to avoid damaging the equipment.
These instructions describe how to operate the equipment safely, economically and in compliance with current safety regulations.
Following these instructions helps avoid dangerous situations, reduce repair costs and down-time and extend the service life of the
equipment.
This manual is to be kept legible and in good condition. The operating and maintenance staff should have this manual at hand so
that they can consult it whenever needed.

1.2 Symbols and qualifications of the operators

All operations described in this manual should be performed by qualified personnel and as outlined in the manufacturer's manual.
Each procedure described herein is accompanied by an icon which indicates the qualifications required by the operators. The
instructions required to identify the personnel qualifications are given below:
Operators
Unqualified personnel capable of operating the equipment under the supervision of qualified people.
Mechanics
Qualified personnel capable of installing, servicing and/or repairing the equipment as directed in this manual.
AUTHORIZED SERVICE POINTS
These are the centers, indicated by our sales staff, authorized to repair the products manufactured by CAMPAGNOLA S.r.l.
WARNING!
• Precautions to be taken in order to safeguard the operators and bystanders in the work area.
• Pay attention to parts with sharp cutting edges. For any intervention, use adequate gloves.
IMPORTANT!
Precautions to be taken in order to avoid problems with the equipment and to operate it in compliance with current safety
regulations.

1.3 Compliance certificate

All equipment to be marketed in the European Union (EU) fully complies with the European Council Directive 98/37/EC.
The compliance certificate is supplied by the manufacturer with the Maintenance & Operations manual.

1.4 Receiving the product

When receiving the product, make sure:
• the product has not been damaged during transport;
• the product supplied is the same as that ordered. Check that all accessories have been delivered (refer to "Product Descrip-
tion", "Specifications" chapter).
If problems arise, contact the manufacturer's service deptartment quoting all details stamped on the nameplate (refer to "Product
Description", "Specifications" chapter).
15 - 56