Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1. Important information
Please read this manual completely and attentively before us-
ing the product for the first time. Keep this manual. It is part of
the product.
1.1 Safety instructions
Caution:
Risk of injury!
Due to the detailed reproduction of the original and the inten-
ded use, this product can have peaks, edges and breakable
parts. For installation tools are required.
Electrical hazard!
Never put the connecting wires into a power socket! Regularly
examine the transformer for damage. In case of any damage,
do not use the transformer!
Make sure that the power supply is switched off when you
mount the device and connect the cables!
Only use VDE/EN tested special model train transformers
for the power supply!
The power sources must be protected to prevent the risk of
burning cables!
1.2 Using the product for its correct purpose
This product is intended:
-
For installation in model train layouts and dioramas.
-
For connection to an authorized model train transformer
(e. g. item 5200) with admitted operating voltage.
-
For operation in dry rooms only.
Using the product for any other purpose is not approved and is
considered inappropriate. The manufacturer is not responsible
for any damage resulting from the improper use of this product.
1.3 Checking the package contents
Check the contents of the package for completeness:
-
2 LEDs with connection cables
-
2 heat shrink tubes
-
2 lamp shades
-
2 lamp glasses
-
Lamp mast
-
Base socket
-
Resistor (multi-coloured rings)
-
Diode (single ring)
-
Manual
2. Introduction
This lamp kit uses SMD LEDs to produce light matching the lamp
model. Low heat build-up and power input. Nearly unlimited life-
time of the LEDs, so no more change is required.
3. Assembly
- See page 2 chapter 3. "Zusammenbau/Assembly".
4
EN
4. Mounting
-
Check function before mounting.
-
Drill a hole (Ø 6 mm) at the mounting place (fig. 1).
-
Put the base socket with the cables from above through the
hole.
Caution:
Never touch the mast but only the patented base socket (fig. 3).
While connecting the cables, leave a loop of about 2 – 3 cm
length below the LED model, so that you can pull and reverse
the LED model from the mounting hole during any work.
Caution:
Resistor and diode at the cables are needed for proper
function of the lamp. Never cut them off (fig. 4)! Never cover
resistor or diode with insulation material, because they have
to be cooled by surrounding air!
5. Connection
Connect the LED model to the lighting power output of a model
train transformer (e. g. item 5200) or power supply as shown
in fig. 4 and/or 5.
DC voltage: Connect the diode (red part with black marker)
with the plus pole of the power supply, the resistor with the mi-
nus pole.
AC voltage: Operation with AC voltage could cause some flickering.
We recommend to use the Viessmann power module, item 5215,
which is sufficient for approx. 100 LED lamps or reflectors (fig. 5).
Connect the cable to the diode with the brown output socket, the re-
sistor with the red output socket of the power module.
6. Technical data
Operating voltage:
(with and without item 5215, power module),
Operating current:
10 – 16 V AC~
14 – 24 V DC=,
13 – 24 V digital signal
ca. 10 mA
5
Werbung
