Yedoo mezeq Bedienungsanleitung Seite 10

EN
ASSEMBLY INSTRUCTIONS
Assembly of the front (bigger)
wheel: open the quick-release
lever and loosen the nut.
Assembly of the rear wheel is
the same as the assembly of the
front wheel with the only excep-
tion of double dropout at the
rear fork. It allows positioning the
footboard according to the road
conditions. The lower dropout
enables off road riding.
18
Downloaded from www.Manualslib.com
Make sure the front fork of the Place the wheel into the front fork
scooter is well positioned (brake so that is well-centred.
levers are facing forward). Release
The tread pattern (arrow-shaped lines
the brake cable from its holder
on the tires) must be pointing to the front.
and loosen the brake arms.
Installation of brake cables:
The upper dropout, which also
makes the footboard go lower press the brake lever to the maxi-
and thus reduces the load on the mum and insert the ending of the
standing leg, is intended for flat brake cable into the circular fixing
surface. Riding will be less tiring. point. Repeat the action with
both brakes.
The rear brake cable is usually fixed on
the right, front brake cable on the left.
manuals search engine
Handlebar installation: place
Tighten the nut (1) until you can
feel resistance before closing the the handlebar tube as shown
quick release. Close it in a way on the picture and tighten the
that the quick release lever (2) screws on the stem.
points backwards (for safety
reasons). Return the brake cable
into the holder.
Adjustment of brake levers: Adjustment of brakes: when
incline the brake levers correctly braking, check that the brake
by loosening the screw on the pads of both wheels fit tightly on
sleeve. the rim sides. If not, you can ad-
just their position via a screw that
The right inclination: stand on the
connects them to the V-brake
footboard, hold the handles and stretch
arms (1). The pads shall not touch
out your fingers in a way that your arm and
the fingers form a single straight line. This the tires.
should be the position of the brake levers.
Insert the handlebar tube into the
front frame (1) and adjust the height
according to the rider's needs
(not higher than indicated by the
line). Check that the handlebar is
upright and properly tighten the
screw on the handlebar tube (2).
Check that the pads make enough
space (1–2 mm) after releasing
the brake levers. The distance
can be adjusted by tightening or
loosening the brake cable at the
anchor screw (2).
In case the brake pad is touching
the wheel when turning, symmet-
rically adjust the distance of brake
arms by the tightening screws (3).
19