Operation; Thermal Cut-Out Reset - Buffalo GL346 Bedienungsanleitung

Telephone Helpline: 0845 146 2887 (United Kingdom)

Operation

Remove the appliance from the
1.
packaging. Make sure that all protective
plastic film and plastic coatings are
thoroughly removed from all surfaces.
Note: Before using for the first
time, clean the interior of the
appliance and all parts in
warm soapy water, then rinse
thoroughly.
Ensure the Temperature Control knob is
2.
set to '0' and tthe power switch is 'Off'.
Remove the lid and fill the appliance to
3.
at least half of its capacity.
Replace the lid.
4.
Connect to the mains power supply and
5.
turn the power switch On. The Power
Indicator light illuminates.
Set the Temperature Control knob to
6.
the required temperature. The Heat
Indicator illuminates and the appliance
heats the water.
WARNING: Reduce the set temperature if the the water begins to boil. DO NOT allow
the water to boil constantly.
When the water has reached the set temperature the Heat Indicator light turns Off.
7.
Note: Once the water temperature drops 5-10ºC then the appliance will reheat the
water.
WARNING: If the Temperature Control Knob is set to or close to '100' then the appliance
will constantly heat the water until the power switch is turned Off or the temperature
is reduced.

Thermal Cut-Out Reset

This appliance is fitted with a Thermal Cut-Out safety feature. Should the temperature exceed safe levels
the appliance will automatically cut power.
The Safety Cut-out switch is located on the underside of the appliance. To reset the appliance:
Empty the appliance and allow to cool.
1.
Press the reset button until it clicks.
2.
WARNING: Ensure the appliance has cooled down and is empty before resetting the
switch, as it may need to be tipped slightly to gain access to the switch.
The appliance is now reset and can be used as normal.
3.
Downloaded from www.Manualslib.com manuals search engine
On/Off switch
Power Indicator light
UK
Lid
Handle
Tap
Temperature
Control knob
3