How To Program A Second "Masterkarte - Feig Electronic ID ZK.AB-A Montageanleitung

Identifikationssystem OBID

4.6 How to program a second "Masterkarte"

In order to guarantee ultimate safety, the factory "Masterkarte" may only be programmed
by FEIG ELECTRONIC GmbH and should therefore be kept in a safe place.
Apart from the factory „Masterkarte", an additional transponder may be authorized as
nd
2 "Masterkarte". For this procedure, you will need the enclosed factory "Masterkarte".
Bring the factory
"Masterkarte" into
the antenna field and
leave it there until the
M"
" appears on the
display.
Remove the factory
"Masterkarte" from
the antenna field.
Bring the transpon-
der, which is to be
nd
used as the 2
"Masterkarte", into
the detection area.
nd
The 2
"Masterkarte" may
now be removed.
The programming
process has been
completed
Notice:
A transponder, which has already been stored as identification card, may not be used as a
nd
2 "Masterkarte". In this case, the display will skip to the respective storage location.
1
only if factory "Masterkarte" is used
FEIG ELECTRONIC GmbH
®
l After the memory
l an "
l The display lights up
H
U W
U \
D
W R
U N
F
H
V W
) D
D
0
l After that, the
l The new transpon-

I r r …
 q
ƒ ‚
 †
U … h
l The display goes
r
… ‡
h
… x
‡ r
†
h
à H

!
M00500.0de-ID-B.DOC
Montageanleitung ID ZK.AB-A
(9.0)
address 190
1
M"
will apear
on the display.
continuously for
approx. 3 s
display flashes for
about 6s
der is now program-
nd
med as a 2
"Masterkarte" and
the right decimal
point lights up.
out.
Seite 42 von 52