hanseatic HGT8566E Gebrauchsanleitung Seite 39

Do not connect to a timer or a sepa-
■
rate remote-controlled system for dis-
tance monitoring and control.
If the mains plug is no longer acces-
■
sible after installation, an all-pole dis-
connecting device complying with
overvoltage category III must be
connected to the house wiring with a
contact gap of at least 3 mm; this in-
cludes fuses, circuit breakers and con-
tactors.
Do not kink or pinch the mains cord
■
or lay it over sharp edges. This can re-
sult in a break in the cable.
CAUTION
Fire hazard!
Improper handling of the appliance can
lead to fi re and damage to property.
Connect the appliance only to a
■
properly installed and earthed elec-
tric socket. Do not connect to a mul-
ti-socket extension cable or a mul-
ti-socket plug.
Start-up
NOTICE
Risk of damage!
If the appliance has been transported
vertically, lubricant from the compres-
sor may get into the cooling circuit.
Allow the appliance to stand upright
■
for approx. 2 hours after transport
and before connecting. This allows
the lubricant enough time to fl ow
back into the compressor.
• Connect the mains plug to a properly
installed socket (see "Technical specifi-
cations" on page EN-26). The Power (7)
indicator lights up.
You will find all important information
about operation from page EN-14.
Page EN-13