Diesel Old-Jack Anleitung Seite 7

1.1) Cheek pad removal/installation
1.2) Crown pad removal/installation
1
2
In order to remove the cheek pads, pull
them in the direction of the arrow as
shown in the figure.
To refit the cheek-pads fasten the press
studs. Check that the cheek pads are
perfectly secured to the helmet.
To remove the crown pad, release the 2
press studs at the front (1) the 2 at the
back of the helmet (2) and slide it out of
the helmet.
N.B. Extract the crown pad ONLY after
releasing all the press studs to avoid
damaging them and prevent damage
to the fabric parts.
To refit the crown pad, insert it inside the
helmet and fasten the 2 press studs at the
back and the 2 at the front into place.
2) RETENTION SYSTEM
There are three types of retention system:
- DD
- Quick release buckle
- Micrometric adjustment
The instructions for the use of all three types are given below.
1
2
3
9 10
2.1) DD retention system
To fasten the helmet, slot the
tape through the two rings
(1), pull the end of the tape
(2) until the strap presses
against the jaw and click the
anti-flapping press-stud (3)
into place as shown in the
figure.
Check that the helmet fits
snugly (see the paragraph
entitled "Choosing the right
helmet" in the "Safety War-
ning" booklet).
To remove the helmet, relea-
se the press-stud by pulling
the end of the tape and loo-
sen the tape, pulling it throu-
gh the rings, using the red
tab as shown in the figure.