Comus Silicone II Bedienungsanleitung Seite 4

Instructionmanual for LED- Rearlight »Silicone II«
GB
Art. no.: 070-50211/ 070-50212
Technical Details and references
With one high-efficiency LED
u
Vehicular optical test requirement, German
u
standard
Equipped with rechargeable lithuim battery
u
With one pc recharger
u
Installation:
Install the light on seat post properly.
u
Aaccording to StVZO §67 the lighting equipment
u
must be fitted correctly and firmly and constantly be
ready for operation. Lighting equipment must not be
covered.
The lowest point of the illuminating surface of the tail
u
lamp shall be not less than 250 mm from the ground
and the highest point of the illuminating surface of
the red reflex reflector may not be located higher than
600 mm from the ground.
The upper housing surface has to be parallel with the
u
ground and perpendicular to the vehicle longitudinal
axis.
When low battery indicator turn ON, the batteries
u
must be changed as soon as possible.
Recharge battery:
Open the USB cover at the bottom of light. Plug in Micro USB cable with connected adaptor or
u
computer, charging indicator from Red (Charging) change to Green (full). Around 2.5hours charge
time.
Plug off the USB cable and close the USB cover.
u
Safety Precaution:
DO NOT LOOK directly into the light.
u
Keep away from heat.
u
Battery fully charge when green indicator turn ON.
u
DO NOT Charge the battery more than 15 hours consecutively.
u
DO NOT use this product while recharging.
u
With ON/OFF-button on top
u
With low battery indicator function. This
u
rechargeable battery frontlight is approved
according to StVZO and meets the required
light values unless the low battery indicator
shows red lightanzeige aufleuchtet.
Seat post
On/Off Switch
Horizon
* Batteries do not belong
to the domestic waste.
As a consumer you have
theobligation to bring the
empty batteries back.