Comus Silicone II Bedienungsanleitung Seite 2

Instructionmanual for LED-Frontlight »Silicone II«
GB
Art. no.: 070-50210 / 070-50212
Technical Details and references
With one high-efficiency LED - 30 LUX
u
Vehicular optical test requirement,
u
German standard
Equipped with rechargeable lithuim battery
u
With one pc recharger, Reloading time:
u
about 3 hours
Installation:
Install the bracket on handle bar properly by tighten the strap. (Fig. 1)
u
Aaccording to StVZO §67 the lighting equipment must be fitted correctly and firmly and constantly
u
be ready for operation. Lighting equipment must not be covered.
Remove light by open the strap if need recharge. (Fig. 2)
u
Adjust the bicycle lamp so that the center of the beam at a distance of 5 m only half as high as
u
the upper edge of the headlight.
When low battery indicator turn ON, the batteries must be recharge as soon as possible.
u
Low battery/charging
indicator
Direction to front
Recharge battery:
Open the USB cover at the bottom of light. Plug in Micro USB cable with connected adaptor or
u
computer, charging indicator from Red (Charging) change to Green (full). Around 3 hours charge
time.
Plug off the USB cable and close the USB cover.
u
Safety Precaution:
DO NOT LOOK directly into the light.
u
Keep away from heat.
u
Battery fully charge when green indicator turn ON.
u
DO NOT Charge the battery more than 15 hours consecutively.
u
DO NOT use this product while recharging.
u
u
u
u
On/Off Switch
Horizontal parallel
to road
Fig. 1
2,5 hours running time
With ON/OFF-button on top
W ith low battery indicator function. This
rechargeable battery frontlight is approved
according to StVZO and meets the required
light values unless the low battery indicator
shows red light.
Fig. 2
* Batteries do not
belong to the domestic
waste. As a consumer
you have theobligation
to bring the empty
batteries back.