DragonTouch DF01G Bedienungsanleitung Seite 5

GETTING READY TO FLY
Note:
① Make sure the propellers and propeller protective covers are correctly installed
and tightened.
② Before flying, please pair the drone and transmitter (remote control), calibrate
the drone and obtain a GPS satellite signal.
1. HOW TO PAIR THE REMOTE CONTROL TO THE DRONE
① Turn on the drone power switch, and place the drone on a level surface.
② Turn on the remote control power switch.
③ Push the left joystick completely up once and completely down once.
You will hear two beeps, and the indicator light will change from flashing
to constant, indicating that the pairing is successful.
2. HOW TO CALIBRATE
① Long press the geomagnetic calibration button for 3 seconds. The remote
control will beep, the drone's front and rear lights will stay on. You have now
entered the geomagnetic calibration mode.
5
② Rotate the drone horizontally. The drone's rear light stays on, and the
horizontal calibration is successful.
③ After successful horizontal calibration, the drone is upright and rotated (360°).
The front light (red light) on the body stays on, and the calibration is successful.
3. HOW TO OBTAIN A GPS SIGNAL
After the gyro and geomagnetic calibrations are successful, the drone's rear light
changes from slow flashing to solid. At this time, place the drone on an open,
horizontal surface. When the drone's rear light turns green, the GPS satellite
signal has been obtained, and you can take off normally. The process takes a few
minutes.
Note: The drone can only fly after a GPS signal has been found. If the flight is
indoors where a signal can not be obtained, the GPS function can be turned off.
To turn it off, tap the remote control GPS switch button. At this time, the remote
control will make a sound, indicating that the GPS function is off and you are
ready to fly indoors.
4. HOW TO TAKE OFF
Method 1: Operate the two joysticks at the same time as shown in the figure pic1
for 2-3 seconds to unlock the drone. Then press the takeoff/land button pic 2.
pic1 pic2
6