Werbung
Verfügbare Sprachen
Verfügbare Sprachen
English
1. To fix the tool holder on the machine,
you need to put it on the axis B and
use the pin for the positioning.
Then tighten the 5 screws of fixations
(Important, make sure that the screws
have the same strength of tightening).
2.
Find the center of the broach and set this
point as 0. Make sure the tool holder is
straight 90° from the sub-spindle.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
GSW-261
3. Calculate the angle for the work piece
you would like to produce.
4. Adjust the angle from the whirling tool
holder with the motorization from the axis
B.
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
BT
d'emploi 1-A.docx
Validation: 25.09.14
2��
tan �� =
��(�� + ��
)
��
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email:
office@pcm.ch
Document:
GSW-261 Mode
Page: 2 de 4
Werbung
