Inhaltsverzeichnis
Werbung
CARO Kids App, we suggest that you do not to log
out unless absolutely necessary.
• Do not quit the App (do not switch up the App) in
order to guarantee the correct functioning of the sy-
stem in any condition.
• In order to verify the correct operation of RECARO
Easy-Tech, it is important to periodically carry out tests to
open/close the accessory, verifying the relative state of the
App (Chapter 1.1, paragraph (e)).
Failure to comply with the above will result in malfunctio-
ning of RECARO Easy-Tech and/or the RECARO Kids App
and the consequent disabling of the system and/or failure
to send and/or receive alarm messages.
CAUTION
Check to perform each time RECARO Easy-Tech is
used:
• Check that the smartphone is on and has enough bat-
tery life when using RECARO Easy-Tech.
• Bluetooth® must be active.
• " Airplane" mode must be deactivated.
• GPS must always be active.
Check the RECARO Kids App for sufficient alarm mes-
sages. If this is not the case, proceed with the purchase
of the necessary package.
• If two or more smartphones are used that have the
RECARO Kids App installed, it is necessary to identify
which one is actually connected to the equipment.
• Before each trip, check that the equipment is comple-
tely closed and that the state detected by the RECARO
Kids App is "connected - child seated. "
Failure to comply with the above will result in malfun-
ctioning of RECARO Easy-Tech and/or the RECARO Kids
App and the consequent disabling of the system and/or
failure to send and/or receive alarm messages.
1.1 HOW TO ACTIVATE RECARO EASY-TECH
a) Download the RECARO Kids App
The RECARO Kids App must be downloaded. When accessing
for the first time, the App will provide all the instructions to
follow to register the account and use RECARO Easy-Tech.
b) Create the family account
A "family account" must be created with a single password.
This account will be the only one that can be used by those
who use that specific equipment. The password is shared with
all users who will interact with the equipment.
IMPORTANT: When creating the family account, an internet
connection must be available (mobile data or WiFi network).
IMPORTANT: In the event that the family password is chan-
ged, the new password must be shared with all users who
share the same family account.
c) Enter the emergency numbers
The emergency numbers to which the alarm mes-wise (se-
cond level) containing the data required to geolocate the child
must be entered when accessing for the first time. A mini-
mum of 3 to a maximum of 5 emergency numbers can be
entered. The emergency numbers must be selected from the
contacts in your smartphone and can be added, deleted and/
or replaced in the future.
IMPORTANT: During this operation, an internet connection
must be available (mobile data or WiFi network).
IMPORTANT: The emergency numbers must be mobile
phone numbers and not landline or national emergency
numbers.
IMPORTANT: Always check that the emergency numbers
are correct and are functioning after entering them.
d) Associating the equipment with the family account
To associate your RECARO Easy-Tech equipment with your fa-
mily account, carefully follow the instructions in the RECARO
Kids App, paying attention to the following.
1) Scan the QR code which is located inside the package
2) Close the equipment (until the green check is completely
visible through the window in the white casing) (Fig.1) to pro-
ceed with the first association. To ensure Bluetooth® con-
nection, make sure you are close to your smartphone. The
system activates/connects a few seconds after the device
is closed.
Up to a maximum of 4 RECARO Easy-Tech devices can be
associated with the same family account. The specific car
equipment can be associated with one family account ONLY.
IMPORTANT: When scanning the QR code, an internet con-
nection must be available (mobile data or WiFi network).
e) Check the correct operation of the equipment
When using the first time, to verify the correct operation of
RECARO Easy-Tech, it is important to do some tests, verifying
the relative state of the App as follows:
- Close the accessory; state detected by the RECARO Kids
App "connected - child seated"
- Then open the accessory: the possible states detected by
the App are either "connected" or "disconnected" depending
on how long it takes between opening the accessory and
displaying it in the App.
f) Enter the information about the baby
After associating the equipment with the family account,
enter the name and date of birth of the child. You can also
enter a photograph.
1.2 HOW RECARO EASY-TECH WORKS
Place the child on the seat and secure him with the re-
straint systems provided for the type of seat in use.
Use the clip (A) on the white casing of the equipment to
attach the accessory preferably to the shoulder strap of the
seat or to the diagonal portion of the seat belt (Fig.2). Now
completely close the equipment as indicated in Chapter
1.1, paragraph d), item 2.
When closed with the green check fully visible through the
special window on the white outer shell, the user is notified
that the product has been activated by means of a special
wake-up acoustic signal.
This is followed by an intermittent sound that informs the
user that the product is searching for the Bluetooth® signal
from the smartphone. A "beep" notifies the user once the
connection has been made successfully.
Make sure that the state detected by the RECARO Kids
App is "connected - child seated. " From this moment on,
the equipment is active and the presence of the child can
be monitored through the RECARO Kids App.
WARNING! If the connection does not occur within 20
Werbung
Inhaltsverzeichnis
