Troubleshooting; Specifications - Beautural 722UK-0001 Bedienungsanleitung

Troubleshooting

EN
Problems Possible Causes
DE
The steamer is not plugged
FR
in, or not switched on.
The water level is too low. Unplug your steamer and refill it.
ES
The steam pump has not
IT
been primed.
There is no
You are using the steamer
steam.
for the first time.
The water tank is not fully
in place.
The steamer is on standby
mode.
There is not enough water
Not enough
in the water tank.
steam coming
The steamer is not heated
out.
to full temperature.
It is not plugged in, or not
switched on.
The steamer
does not heat. The steamer is on standby
mode.
The water tank is not fully
in place or the cover is not
closed properly.
Water leaks.
There water tank is
overfilled.
The steamer is not heated
to full temperature before
use.
There is remaining water
Water spits.
after last use which
became condensation
water and stored in the
steam head.
The steam You are using water with
leaves stains additives.
on the
The water in your home
fabric or the
too hard.
steamer spits.
Solutions
Check that your steamer is correctly
plugged in and switched on.
Press the steam trigger continuously for
a few seconds to begin steaming.
Press the steam trigger continuously for
a few seconds to begin steaming.
Ensure that cover is closed and that the
water tank snaps when put into place.
Please refer to the "Standby Mode"
section.
Follow the instructions under the "Before
Use" section and fill to Max level.
Always allow steamer to preheat until
the power indicator light becomes solid.
Plug in your steamer and switch on.
Please refer to the "Standby Mode"
section.
Ensure that cover is closed and that the
water tank snaps when put into place.
Fill the water tank to the Max. level, do
not overfill.
Before steaming, always allow steamer
to preheat until the power indicator
light becomes solid.
After each use, empty the water tank
and power on the steamer to heat the
steamer for about 2 minutes to dry out
any remaining water.
Never add any additive in the water tank.
Read carefully the "What water to use"
section.
8

Specifications

Rated voltage:
For US: AC 120V ~ 60Hz
For UK: AC 220-240V ~ 50/60Hz
Rated power: 1200W
Water tank capacity: 0.26 liters (8.8 fluid ounces)
Steaming Tips
To Steam Garments
1. Place the fabric in a dry and ventilated place and at least 20 cm (8
inches) away from any walls (otherwise moisture may cause mildew).
2. Empty garment pockets and straighten turn-ups such as cuffs and
hems.
3. Hang the garment from a hanger and stretch the fabric slightly with
one hand, making sure there is nothing behind the fabric that could be
damaged by the steam.
4. Put the steam head against the garment, pressing and holding the
Steam Activation Button while moving your arm in an up and down
motion, targeting creases on the fabric.
NOTE: Do not steam over metal accessories. Use with caution when
steaming around metal accessories.
WARNING: When using the garment steamer, do not touch the steam
head. This garment steamer will generate a large flow of high temperature
air that can cause burns if not handled carefully.
9
EN
DE
FR
ES
IT