Werbung
Using Other Brand Dies
For Use With Non-Cuttlebug Thin Dies.
1. Position materials as shown, using
thin die adapter C instead of second
cutting pad B.
2. Move materials through Cuttlebug
machine by turning handle.
3. Remove all material from die;
discard unwanted pieces.
Fig 6
TIP
• For best results, experiment with scrap paper first.
Downloaded from
www.Manualslib.com
Cutting pad
Paper
Cutting Die
Cutting pad
Spacer
manuals search engine
Using Other Brand Dies
For Use With Steel Rule Dies.
1. Position materials as shown
using only the cutting pads B
excluding the spacer block A
from the assembly.
2. Move materials through Cuttlebug
machine by turning handle.
3. Remove all material from die;
discard unwanted pieces.
Fig 7
TIP
• For best results, experiment with scrap paper first.
Cutting pad
Steel Rule Die
Paper
Cutting pad
Werbung
