Herunterladen Inhalt Inhalt Diese Seite drucken

Ring Automotive PowerSourcePro RINV1100 Handbuch Seite 7

Inhaltsverzeichnis

Werbung

Downloaded from
www.Manualslib.com
PowerSource Instructions Euro
3
Do not place or operate
the PowerSourcePro in or
around flammable
environments.
Il ne faut pas placer
l'onduleur
PowerSourcePro dans un
milieu ambiant
inflammable ni l'utiliser à
proximité de ce milieu.
Den PowerSourcePro nicht
in oder in der Nähe
entflammbarer Bereiche
aufstellen oder betreiben.
4
The PowerSourcePro can
be mounted vertically or
horizontally. If mounted
vertically ensure the
ventilation openings are
pointed downwards.
L'onduleur
PowerSourcePro peut être
monté à la verticale ou à
l'horizontale. S'il est
monté à la verticale,
veiller à ce que les
ouvertures de ventilation
soient orientées vers
le bas.
Der PowerSourcePro kann
senkrecht oder
waagerecht aufgestellt
werden. Bei senkrechter
Aufstellung dafür sorgen,
dass die
Belüftungsöffnungen nach
unten zeigen.
manuals search engine
17/9/08
1:45 pm
Page 7
Non collocare/utilizzare
PowerSourcePro in
ambienti infiammabili o in
prossimità di questi.
No debe colocar o poner
a funcionar el
PowersourcePro en o
cerca de lugares
inflamables.
Não coloque ou opere o
PowerSourcePro em
ambientes inflamáveis ou
perto deles.
PowerSourcePro s'installa
in posizione verticale o
orizzontale. In posizione
verticale, accertarsi che gli
sfiati siano rivolti verso il
basso.
El PowerSourcePro puede
usarse horizontal o
verticalmente. Si se usa
verticalmente, debe
asegurarse que la apertura
de ventilación quede
hacia abajo.
O PowerSourcePro pode
ser montado vertical ou
horizontalmente. Se o
colocar verticalmente,
assegure-se de que as
aberturas para ventilação
estão viradas para baixo.
7
Placera eller använd inte
PowerSourcePro i eller
nära brandfarliga miljöer.
Plaats of bedien de
PowerSourcePro niet in of
nabij omgevingen met
brandbare stoffen.
PowerSourcePro må ikke
anbringes eller betjenes i
eller omkring brændbare
miljøer.
PowerSourcePro kan
monteras lodrätt eller
vågrätt. Vid lodrät
montering ska du
kontrollera att
ventilationsöppningarna
pekar nedåt.
De PowerSourcePro kan
verticaal of horizontaal
worden gemonteerd.
Indien deze verticaal
gemonteerd wordt,
moeten de ventilatie-
openingen naar beneden
gericht zijn.
PowerSourcePro kan
monteres lodret eller
vandret. Hvis den
monteres lodret, skal det
sikres, at
ventilationsåbningerne
peger nedad.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis