BeeWi BBT101 Gebrauchsanleitung Seite 7

7
Note: if the Transmitter is not connected to any device, it will automatically
turn off after 5 minutes.
2.2. Pairing
- make sure the headphones or speakers you would like to pair the Trans-
mitter with is in "Pairing" mode (refer to the headphones or speakers user
manual).
- The Transmitter being powered off, press and hold the mFB for about 6
sec until the LED starts blinking blue and red. The transmitter will automa-
tically find the device, pair and connect to it. When connected to a single
device, the Transmitter will flash once every 4 seconds.
- To pair a second headphones or speakers, press twice the mFB. The
LED will blink blue rapidly until the second device is found, paired and
connected. When connected to 2 devices, the Transmitter will flash twice
every 4 seconds.
Notes:
- The Transmitter supports pass code "0000", "1234", "1111" and
"8888" for a wide compatibility. Pairing will not work with playback de-
vices generating a random pass code.
- It is possible to pair the Transmitter with up to 8 devices (only 2 being
connected at a time)
- The paired device list can be reset by long pressing the mFB for about 10
sec when the Transmitter is off.
2.3. Connection & use
The Transmitter will automatically connect to the last 2 connected devices
when it is powered on. If you wish to manually connect a device, just long
press the Transmitter mFB. make sure the headphones you wish to connect
to are turned on prior to request the connection from the Transmitter and
they are not already connected to another device. Note most of the de-
vices can also connect automatically when they are powered on if the
Transmitter is already in standby mode.
During music streaming, the KSS sound limiter can be enabled or disabled
by pressing mFB shortly.
ENGLISH
Downloaded from www.Manualslib.com manuals search engine