Set Alarm; Activate Alarm; Temperature; Select Channel Number - Oregon Scientific Rar621 Bedienungsanleitung

SET ALARM

1. Press to display the type of Alarm you wish to
set: Weekday or Single.
2. Press and hold
settings will blink.
3. Select the hour and minute. Press
settings. Press

ACTIVATE ALARM

Press or to activate or deactivate the Alarm. "-:--"
indicates that the alarm is deactivated.
RAR621 English R4 OP
Downloaded from www.Manualslib.com
again for 2 seconds. The Alarm
or to change
To confirm.
11
Black
manuals search engine
STOP ALARM
To stop the alarm from ringing, Press

TEMPERATURE

This product can display current, minimum, and
maximum temperature information collected by the
remote sensors and main (indoor) unit.
Outdoor data is collected and displayed every
78 seconds. Indoor data is collected and displayed every
10 seconds.

SELECT CHANNEL NUMBER

Press CHANNEL to switch between sensors 1-3.
The icon shows the selected sensor.
Kinetic-
wave icon
Designat- Indoor
ed Display
Display
To auto-scan between sensors, press and hold
CHANNEL for 2 seconds. Each sensor's data will be
displayed for 3 seconds. To end auto-scan, press
CHANNEL or MEM.
11
8/18/04, 5:29 PM
.
Remote Remote Remote
Display Display Display
Channel 1 Channel 2 Channel 3