Select Operation Mode; Basic Functions - JGC -MS-2305 Bedienungsanleitung

Design micro system

Vorschau ausblenden

Inhaltsverzeichnis

Verfügbare Sprachen

Instructions for remote control

• Make sure that no objects are located between the infrared LED (34) of the remote and the infrared

sensor (5) on the device.

• Please note that direct sunlight or room lighting influences the correct function of the remote control. If the

remote control does not work properly, try to darken the area or reduce the distance between the device and

the remote control. If the problem persists, replace the batteries in the remote control.

• The buttons on the remote correspond to their function with the buttons on the device. All main functions

can be performed with the remote control.

• The following functions are carried out and explained with the remote control unless otherwise indicated.

Switching device on and off

• Plug the power cord into an appropriate outlet.

• Switch on the device using the power switch (29) on the rear side. The device is in standby mode and the

standby LED (18) illuminates red. The clock display on the LCD display (1) flashes as long as the clock has

not been set.

• Press the STANDBY button (33) in order to switch on the device. Press the button again in order to switch

the device into standby mode.

• With the power switch on the back side, switch off the standby power supply.

• To completely disconnect from the network, pull the plug from the outlet.

Notes:

• If audio files are not played and no button is pressed in CD, USB or CARD mode, the device will automatically

switch to standby mode after 15 minutes.

• The device heats up if it is operated for a long period of time. This is normal and not a malfunction of the

device.