Charging The Helicopter Battery; Charging Instructions; Battery Charging Information; Installing Transmitter Batteries - SYMA S40 Bedienungsanleitung

8.0 Charging the Helicopter Battery

8.1 Charging instructions

Plug the USB cable into the computer's USB port (The indicator light on the USB cable lights
up); then connect the USB cable to the battery(The indicator light lights off). Unplug the USB
cable, when the indicator light lights up again.
The charging time is about 60 minutes; The flight time is about seven minutes.
8.2 Important: battery charging information
1. Rechargeable batteries should be removed from the toy before being charged.
2. Rechargeable batteries should only be charged under the supervision of adults.
3. Exhausted batteries should be removed from the aircraft.
4. Caution: Risk of explosion if battery is replaced with incorrect ones. Please dispose the
batteries according to the instructions.

9.0 Installing Transmitter Batteries

4 x AA Batteries
Transmitter battery installation: open the battery cover at the back of the transmitter. Install
4pcs AA batteries according to the polarity indications (Note: batteries are not included).
1. During the battery installation, it must be ensured that the polarities of the batteries
are matched with that of the battery box. No battery shall be installed with the opposite
polarity.
2. Please do not use new and old batteries together.
3. Please do not use different types of batteries together.
4. Do not use rechargeable batteries.
-6-
English
Battery Cover